iSpring LS43 Water Leak Detector Alarm System with Automatic Shut-off Valve and 2 Detection Sensors, Connects Up to 8 Sensor to Prevent Flooding

$151.99

About this item

iSpring water leak detection system is designed and to be installed on whole house water pipe to detect and set alarm for possible leak and shut off water supply automatically to prevent flooding
Includes 2 water sensors. The controller unit is able to connect up to 8 water detection sensors
Includes a 3/4” NPT automatic shut-off ball valve
Requires a power outlet for the controller unit
1-year warranty with lifetime support from iSpring

Frequently Bought Together

iSpring LS43 Water Leak Detector Alarm System with Automatic Shut-off Valve and 2 Detection Sensors, Connects Up to 8 Sensor to Prevent Flooding

$151.99

Automatic Shut-Off

The leak-detecting sensor that automatically turns off the valve once water is detected helps prevent major flooding and water damage.
Quick and loud alarm

Sounds an alarm immediately to warn people in the house to check. It can be turned off quickly with the RESET button.

Connect up to 8 sensors

This controller unit can connect up to 8 water detection sensors, allowing you to cover the whole water pipe area in the house.
Easy-operated Controller

8 LED lights indicating which sensor has detected water. Three buttons give you different choices to interact freely with the controller.

What’s included

Ball valve with sound/light alarm
Controller module
5V / 1A Transformer
2 pieces of water sensors

Step1: Install the ball valve to the pipe.

To install the ball valve, shut off the main water supply line, turn on a faucet on the water supply line, drain out the remaining water and air in the pipe. Locate the ball valve's position to be installed, use a pipe cutter to cut the sides of the pipe. Put the ball valve into the spliced pipe. Please note that sweat joints/plumber's cement(not included) may be needed to secure the installation. Depending on the type of the pipes, couplers(not included) may also be required to close the installation.

Step2: Mount the control module on the wall.

The control module should be mounted at a location close to the application that is vulnerable to water leakage, and a power outlet is required.

Step3: Make sure the location is damp.

Place and spread the sensors on the ground. Up to 8 sensors are supported. For best performance, drop the sensors at places close to the wall and which may have direct contact with water in case of a leak incident.